Lubricating oil and coolant according to the regulations. It is strictly forbidden to use inferior oil during the running-in period of the new machine, and it is strictly forbidden to add inferior coolant (sewage). It is recommended that the new machine be used for the first time to replace the oil and maintain the oil filter within 500-1000 kilometers in advance.
Check whether the coolant, oil, etc. are sufficient at any time. If the amount is found to be lacking or leakage, it should be eliminated and adjusted in time.
The new machine is not allowed to be put into normal use without running-in, it should be installed on the car and run for 1000 kilometers according to the specifications of the running-in period in "Table 1"; or Run in for 2-4 hours on a professional run-in bench according to the run-in specification. For the rocker-arm gasoline engine, check and adjust the valve clearance and ignition timing again after the running-in period of 1000 kilometers, so that the engine can achieve a good working condition. During the break-in period, it is strictly forbidden to drag gears at high speed and low gear or at low speed and high gear.
When the new machine is running on the car, it is best to run it on the cement road or asphalt road, and try to avoid driving on the muddy dirt road. Cuando la nueva máquina está funcionando en el automóvil, es mejor hacerlo funcionar en el camino de cemento o asfalto, y tratar de evitar conducir en el camino de tierra embarrado.
When the new machine is started, it should not run at high speed immediately, and it must be preheated for 2-3 minutes to use the machine to preheat.
After the new machine is installed, it should be maintained and adjusted according to the requirements of "Table 2" after the running-in period.
Others that are not specified shall be implemented in accordance with the provisions of the vehicle engine instruction manual.
Where customers due to improper use, unauthorized modification, improper maintenance. For example: use inferior oil, inferior third filter; not maintain the third oil filter over time; even the air filter is not installed or fails to install. Manufacturers do not give three guarantees. Failure to use the product in accordance with the above precautions shall be borne by the customer.